Sada nástrojov Iwata CL-500 pre údržbu airbrush pištolí

Profesionálne vyrobená 6 dielna čistiaca sada pre čistenie rôznych druhov airbrush striekacích pištolí. Vďaka svojmu obsahu umožňuje udržiavať poriadok na Vašom stole. VĎaka tejto sade dokážete urobiť údržbu na akejkoľvek airbrush pištoli Iwata.

Sada Obsahuje:

Iwata Needle Packing Screw Driver. Set of two.

Sometimes it can become necessary to maintain the fluid needle packing screw set. You may want to remove it for a thorough cleaning or you may occasionally need to replace the needle packing set. Though it can be a tricky process, the Iwata Needle Packing Screw Drivers make it much easier to maintain or replace. The Kit comes with a set of two screw drivers (for 1.2mm and 1.4mm diameter needles) and a listing of which Iwata models they serve. Most standard size Iwata airbrushes fit one of these screw drivers. (Eclipse G Series airbrush guns excluded).

Some of the older Iwata airbrush models use two piece rubber O-ring seals and a needle packing screw. Newer brushes have a one piece PTFE (Polytetrafluoroethylene) needle packing set. Kirk says “When replacing PTFE seals, be careful not to over tighten the needle packing set because the PTFE does not spring back into shape as readily as does the older rubber O-rings.” The tightness of the needle packing screw adjusts how the needle slides within it. You need to have enough tightness to seal around the needle and prevent paint from flowing back into the body from the paint cup area. But, too tight and the needle will not move freely and the main lever will not be able to accurately control the needle movement. The special shape and design of the Iwata Needle Packing Screw drivers make it easy to “feel” how tight you are adjust- ing the needle packing screw on the needle. With each driver having the same pin diameter as the needle, you can adjust the tightness by sliding the pin within the seal as you make fine adjustments to the tightness of the needle packing set.

Iwata Air Valve Guide Wrench. 2-sided.

The Iwata Air Valve Guide wrench allows you to access the air valve parts for cleaning or replacing. The wrench has both small and large diameter ends that correspond to different Iwata airbrush models. The instruction booklet contains a listing of models and directs you to the corresponding wrench-end for that brush. Simply fit the wrench into the two slots of the air valve guide and unscrew. You can also loosen or tighten the air valve guide to customize the “push down” main lever tension to your ultimate preference.

Iwata Soft Jaw Pliers

The Iwata soft Jaw Pliers can be used whenever you need to assemble or disassemble your airbrush. These pliers are so useful because the nylon jaw inserts grip firmly around the part without damaging the chrome surface.

Use them to remove parts such as nozzle caps, needle caps and handles. No more marring chrome surfaces like with traditional pliers.

Iwata Nozzle Wrench